Overview

Water based Dulux Trade Weathershield Quick Dry Exterior Satin is a mid sheen finish, part of a paint system specifically developed to give long lasting protection for exterior wood. If correctly applied according to the instructions, tests have shown that Weathershield Quick Dry Exterior Satin will provide extended protection of up to 6 years on exterior wood. This product contains a fungicide to inhibit mould growth on the paint film and help it stay cleaner for longer. Superb coverage and a tough, durable finish make this a superior exterior paint for wood, primed metal and plastic.

• Up to 6 years weather protection
• Inhibits mould growth
• Mid sheen finish

Preparation

To get the best results, ensure surfaces to be painted are sound, clean and dry (new surfaces particularly must be fully dry).

• Remove all loose and defective coatings, if necessary stripping back to bare wood. Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead.
• Remove and treat any mould, algae, lichen or moss with .
• Remove defective glazing material, clean the rebates and any loose or open joints. Replace any rotten wood and troublesome knots with new timber.
• When painting plastic rainwater goods, apply a coat of Weathershield Quick Dry Exterior Satin thinned to 1 part clean water to 10 parts paint direct to the surface.
• Fill any surface defects, open joints etc. and replace any missing glazing material. New joinery is often factory primed using a stain base coat, also known as a dual-purpose primer. These materials quickly erode when left exposed and may need to be re-primed.

Application

Stir thoroughly, it is recommended that a small test area is applied before treating the entire surface to ensure compatibility.

• Stir the paint thoroughly before you begin to ensure even coverage. Apply with a brush only. Do not spray. Do not thin.
• Apply 1 coat of the appropriate coloured to all primed wood.
• Apply a second coat of Weathershield Quick Dry Exterior Undercoat overall, followed by 1 coat of Weathershield Quick Dry Exterior Satin.
• Where there is a strong colour change, 2 coats may be needed. Allow a minimum of 2 hours before overcoating Weathershield Quick Dry Exterior Undercoat.
• When painting resinous wood or woodwork with a history of blistering, it is recommended that you use light colours only, particularly on south facing areas.
• The maximum benefits of this system will only be realised when used as directed above on good quality timber that conforms to BS EN 942: 1996, in conjunction with good component design.

Note: Always follow the manufacturer's instructions found on the tin.

Aftercare & Storage